Changing Accessories - Cocraft HMT300 Original Instructions Manual

3. Turn the locking lever back so that
it stands at 90° from the front of
the machine. The locking washer
cannot fall from the tool mount when
the locking lever is in this position.
5. Turn the locking lever back fully.

Changing accessories

See the figures above.
1. Turn the locking lever so that it is positioned at 90° from the front of the machine.
2. Remove the tool from the mount.
3. Slide in the tool of your choice under the washer and up onto the mount so that the mounting
pins align with the holes on the tool (it is up to your discretion on what angle to set the tool).
4. Turn the locking lever back completely.
Tools with snap-in fittings
The locking washer must first be removed whenever attaching tools with snap-in fittings.
1. Snap-in fitting:
4. Slide in the tool of your choice under
the washer and up onto the mount so that
the mounting pins align with the holes on
the tool (it is up to your discretion on what
angle to set the tool).
2. Turn the locking lever
out fully.