Troubleshooting Guide; Care And Maintenance - Cocraft PSJ750GH.1 Original Instructions Manual

Sawing metal
• Be careful, the saw blade can easily bend.
• Use a finer toothed blade if the jigsaw vibrates a lot during operation.
• Lower the speed if the saw blade becomes very hot.
• The use of some kind of lubrication/coolant is recommended, e.g. alcohol for
aluminium and cutting oil for steel.
• When cutting thin sheet metal, it is advisable to clamp the sheet to a sheet of thin
plywood or similar on either side of the metal. Then saw through all the layers.

Troubleshooting guide

The saw does •
not start.
•
The saw runs •
slowly.
•
•
Heavy •
vibrations. •

Care and maintenance

• Warning: Unplug the jigsaw and remove the blade before any service or adjustment.
• If the mains lead is damaged it should only be replaced by a qualified electrician.
• Clean the jigsaw by wiping it with a damp cloth. Use only mild cleaning agents,
never solvents or corrosive chemicals.
• Keep the motor ventilation openings free from contaminants.
• If the jigsaw is not to be used for an extended period, it should be unplugged and
stored in a dry and dust-free location out of reach of children.
Responsible disposal
This symbol indicates that this product should not be disposed of with
general household waste. This applies throughout the entire EU. In order
to prevent any harm to the environment or health hazards caused by
incorrect waste disposal, the product must be handed in for recycling
so that the material can be disposed of in a responsible manner.
When recycling your product, take it to your local collection facility or
contact the place of purchase. They will ensure that the product is
disposed of in an environmentally sound manner.
Make sure that the mains lead is undamaged and securely
plugged into a wall socket.
Make sure that the wall socket is live.
Adjust the speed setting. Refer to the Speed setting
section above.
Remember not to use too much force on the blade when
cutting. Let it work at its own pace.
Is the blade worn? Replace if necessary.
Make sure that the footplate is held against the workpiece.
Check that the blade is in good condition and is correctly fitted.
12