Operator Safety Instructions - Pioneer Eclipse Mean Machine Operator's Manual

Propane burnisher with kawasaki engine
Table of Contents

Advertisement

Operator Safety
Instructions
DANGER! Operate this machine only in a
well-ventilated area. It is the
responsibility of the machine operator,
machine owner, and site manager to
ensure that the air exchange system
where the machine is to be used is in
compliance with local building codes and
is operating properly. Failure to operate
this machine in a well-ventilated area
could lead to sickness, injury or death
from carbon monoxide (CO) exposure.
DANGER! This machine emits carbon
monoxide (CO) which is a colorless,
odorless, non-irritating gas. The first
symptoms of CO exposure include
headache, drowsiness, dizziness and
nausea. If you should experience any of
these symptoms while operating this
machine, shut off the machine and go
outside to get fresh air. Have the
machine tested for CO emissions by a
qualified service technician before using it
again.
DANGER! Prolonged or high exposure to
CO may result in vomiting, confusion, and
collapse in addition to loss of
consciousness and muscle weakness. If
such symptoms occur, call 911 for
emergency medical attention. If you have
experienced these symptoms, do not
operate this machine or any other
propane machine again until cleared by a
physician. Excessive exposure to CO
can result in death.
DANGER! Propane is a highly flammable
fuel. If you smell propane, shut off the
machine immediately and take it outside
the building. Do not use the machine
again until the propane leak has been
corrected by a qualified service
technician. Do not use or allow another
person to use an ignition source such as
a cigarette lighter near the propane
machine. Do not smoke near the
propane machine. Do not vent a propane
cylinder inside a building. Do not store
propane cylinders inside a building.
DANGER! This machine has parts including
the pad and pad holder that can cause
severe injury if these parts are contacted
while they are moving. Do not allow any
part of the body or clothing to come in
contact with these parts while they are
moving. Do not try to change the pad
while the machine is running. Do not
allow other people to come near the
machine while it is in operation. Do not
allow the machine to run unattended. Do
not leave the machine in a place where
unauthorized or untrained personnel
could use the machine. Do not run the
machine with the pad off center, damaged
or missing. Do not operate the machine if
the machine has loose parts such as the
drive belt.
WARNING! Modifications or alterations to
this machine can lead to personal injury
or damage to the machine. Do not make
unauthorized modifications or alterations
to this machine. Amano Pioneer Eclipse
assumes no liabilities for injury or
damage resulting from an unauthorized
modification or alteration to the machine.
Any unauthorized modification or
alteration to this machine voids all
warranties.
WARNING! The muffler and the engine
become hot enough while the machine is
in operation, and for a long time after the
machine is shut off, to cause severe
burns. Do not touch these parts of the
machine until they have cooled.
WARNING! Injury can occur to the eyes and
body while using the machine. Safety
goggles, safety shoes, and safety clothing
are recommended while operating the
machine.
WARNING! Continuous exposure to high
noise levels can cause hearing loss.
Hearing protection is recommended while
the machine is in operation.
WARNING! Machine vibration may cause
tingling or numbness in the fingers or
hands. Gloves are recommended to
reduce machine vibration. If tingling or
numbness persists, shut off the machine.
If the vibration is caused by loose parts
such as the drive belt or an off center
pad, adjust or tighten these parts before
using the machine again.
CAUTION! Overfilled cylinders can damage
fuel regulators. Do not overfill the
cylinder. If the regulator freezes, stop the
burnisher and carry the propane cylinder
outside the building.
CAUTION! Overheating can be caused by a
dirty engine filter which is also known as
a bonnet or top hat filter.
CAUTION! Overheating can be caused by
insufficient or low oil. Check oil before
each use, and fill or change as needed.
CAUTION! Never over-fill with oil. Over-
filling could cause irreparable damage to
the engine.
CAUTION! Overheating can be caused by
dirty oil. Check oil before each use and
change regularly following recommended
maintenance schedule.
CAUTION! Do not engage starter for more
than 10 seconds. Allow a 60 second cool-
down period for second failed start-up
attempt.
CAUTION! Perform all recommended
scheduled maintenance. Regular
maintenance of your propane powered
floor machine is necessary to keep it in
safe working condition.
CAUTION! Do not allow the burnisher to
operate without moving the machine. It
may burn the floor and damage the floor
covering.
This machine is manufactured for
commercial use only.
Propane powered floor burnishers are
designed and manufactured for ultra high
speed commercial floor burnishing only.
These machines are designed to burnish
most modern types of floors including
composition tile, stone, marble, terrazzo, and
resilient floor covering using floor coatings
designed for ultra high speed burnishing.
Even though NFPA 58 8-4.5 says ..."these
machines shall be permitted to be used in
buildings frequented by the public, including
the times when such buildings are occupied
by the public," Amano Pioneer Eclipse
suggests usage when occupancy of a given
work area is minimal.
These machines should not be used:
in nursing homes, hospitals, day-care
centers, etc.
by unqualified or untrained personnel.
unless properly maintained and adjusted.
on areas with obstructions such as
thresholds, floor outlet boxes, etc.
in areas where loose tile or other objects
are present.
in rooms without proper ventilation.
Refueling and Storage of Fuel
Cylinders
Amano Pioneer Eclipse uses the 20 lb.
capacity aluminum or steel safe-fill cylinder
which meets the DOT 4E240 standards.
These cylinders are also listed by UL. Filling
should be done ONLY by a qualified propane
dealer. FILL THROUGH THE SERVICE
VALVE ONLY. A properly filled cylinder
should not exceed 80% of the rated capacity.
DO NOT attempt Safe-Fill cylinder repair.
Return the cylinder to your propane dealer if
repair is necessary. Please note that DOT
regulations prohibit shipping of cylinders after
the cylinder has been filled with propane.
When not in use, they always should be
stored outside in an upright position in a
secure, tamper-proof, steel mesh storage
cabinet. This cabinet may be located next to
the building but with at least five feet (1.5 m)
of space between the cabinet and the
nearest building opening (door or window).
The National Fire Protection Association
(NFPA) Standard for Storage and Handling of
LP Gas is the appropriate authority for safe
propane use. A copy of this publication is
available through the National Fire Protection
Association in Quincy, Massachusetts
(1-800-344-3555).
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mean Machine and is the answer not in the manual?

Questions and answers

Table of Contents