Although your vehicle has been thoroughly checked before delivery, problems may occur during operation.
The fault detection table below shows quick and easy test methods that you can use to perform a quick check
yourself. If your vehicle needs repairs, please contact your dealer who has the tools, expertise and experience
to service your vehicle properly.
FAULT IDENTIFICATION LIST
ERROR
Engine does not start when the
start button is pressed
Engine revs but does not start
or stalls
Poor engine performance
Increased oil consumption
Engine indicator light comes on
CAUSE
•
Battery discharged
•
Fuse blown
•
Starter relay defective
•
Starter motor defective
•
Emergency stop switch actuated
•
Fuse blown
•
Wrong idle speed
•
Spark plug fouled
•
Fault in injection system
•
Cable damaged
•
Problem with plug contact
•
No fuel in tank
•
Fuel pump defective
•
Fuel filter dirty
•
Leak in fuel system
•
Air filter contaminated
•
Fuel filter dirty
•
Fault in fuel system
•
Fault in ignition system
•
Valve clearance too low
•
Oil level too high
•
Cylinder/piston worn
•
Engine ventilation defective
•
Fault in the electronics or injection
system
FAULT DETECTION
MEASURE
•
Charge battery
•
Change fuse
•
Replace starter relay
•
Replace starter motor
•
Move emergency stop switch to
correct position
•
Change fuse
•
Check idle speed
•
Change spark plug
•
Check injection system
•
Check cables
•
Check plug contacts
•
Refuelling the vehicle
•
Check fuel pump
•
Replace fuel filter
•
Check fuel system
•
Replace air filter
•
Replace fuel filter
•
Check fuel system
•
Check ignition system
•
Adjust valve clearance
•
Drain oil to maximum level
•
Replace parts
•
Check engine ventilation
•
Fault diagnosis by authorised
specialist dealer
Mission 125 / 200 21