Battery; Fuses - Malaguti MISSION 125 Instruction Manual

Table of Contents

Advertisement

MAINTENANCE & SERVICING

BATTERY

The battery (1) is located under the seat. This model
is equipped with a sealed and maintenance-free
battery. There is no need to refill battery acid or
distilled water.
WARNING
Do not remove the battery cell seal under any
circumstances! This can be dangerous and will
permanently damage the battery.
Battery acid is toxic and dangerous! It contains
sulphuric acid and can cause dangerous
chemical burns.
Avoid skin, eye and clothing contact and always
protect your eyes when working near the battery.
In case of contact, render FIRST AID immediately.
In case of skin or eye contact with battery acid,
rinse the affected areas with plenty of water.
If battery acid is swallowed, drink large quantities
of water.
In both cases, seek medical attention as soon
as possible.
Batteries emit explosive hydrogen gas. Keep
naked flames, cigarettes, etc. away from the
battery and provide adequate ventilation when
charging a battery indoors.
KEEP BATTERIES AWAY FROM CHILDREN.
Charge battery
If you do not have a suitable charger, contact your
dealer to have the exhausted battery charged. The
battery discharges more quickly if you have fitted
electrical accessories.
Store battery
If the vehicle is not used for more than one
month, remove the battery from the vehicle.
20 Mission 125 / 200
Fully charge the battery and store it in a cool,
dry place.
If the battery is stored for more than two
months, check the charge level at least once
a month and recharge the battery if necessary.
Fully charge the battery before reinstalling it.
After installation, make sure that the battery
cables are connected correctly.
WARNING
If you are not familiar with how to handle the
battery, contact a specialist dealer.
NOTE
Always keep the battery charged. Storing a depleted
battery will permanently damage the battery.

FUSES

The fuses are located under the battery cover.
Change fuse
Turn the ignition key to
electrical consumers.
Remove the blown fuse and insert a new fuse
with the same ampere rating.
WARNUNG
Do not use a fuse with a higher ampere rating as this may
cause serious damage to the electrical system or fire.
After changing the fuse, turn the ignition key to
the
and switch on the electrical consumers
to check.
If the fuse blows again, please contact your
specialist dealer and have the electrical system
checked.
and switch off all

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mission 200

Table of Contents