Table of Contents
Advertisement
STEP 1
1.1) Figure 1.1 is a typical configuration for installation of the drain systems. The actual configuration will vary
depending on your cabinet and sink configuration.
PIPING SHOWN ONLY
FOR CLARITY.
STEP 2
Install the Discharge Pipe onto the Pump ( All Models)
WEEP HOLE
Note: Model 105 shown.
Determine Installation Configuration
Figure 1.1
DISCHARGE PIPE
PUMP DISCHARGE
Figure 2.1
© Copyright 2012 Zoeller Co. All rights reserved.
BE SURE THAT WEEPHOLE
IMPORTANT
IS NOT DIRECTED TOWARD THE FLOAT!
Water stream will be visible from this hole
during pump run periods.
4
SK2367
SK2002B
Advertisement
Table of Contents
