Table of Contents
Advertisement
Home Grinder X54
Operation
Operating steps at a glance
The basic operating steps for using the
grinder are shown in brief in this Chapter.
Detailed
points can be found in the corresponding
sub-chapters.
1. Switch on the grinder
2. Select the collecting receptacle (24)/(25) and insert
the matching module (18)/(21)
collecting receptacle (portafilter vs. container)"] / [see „Using the
portafilter module"] / [see „Using the container module"]
Important: If you are using the portafilter module
and want to change settings, do not insert the porta-
filter yet. You start the grinding process by inserting
the portafilter.
3. Select the desired recipe or the Manual Grinding
mode
[see „Selecting Recipe / Manual Grinding"]
If the recipe or manual grinding has already been set
as desired, skip this step and continue with Step 4.
4. Set the grinding degree
If the grinding degree has already been set as desired,
skip this step and continue with Step 5.
5. Insert the collecting receptacle and start the grinding
process
[see „Starting grinding"]
32
descriptions
[see „Switching on the grinder"]
[see „Adjusting the grinding degree"]
.
of
the
individual
[see „Selecting the
.
.
.
.
Advertisement
Table of Contents
