Removing The Portafilter Module; Using The Container Module; Inserting The Container Module - Mahlkonig X54 Original Instructions Manual

Home Grinder X54
The two pins on the back of the module slide into the
holes in the module area.
The portafilter switch in the module area slides
smoothly through the opening in the module.
3. Release the pushbutton.
The pins on the back of the module engage in the
module area and lock the module in the correct
position.

Removing the portafilter module

1. Press and hold down the pushbutton on the side (7)
to remove the module (18).
This is how the locking of the module is released.
2. Carefully remove the module from the module area
(11) towards the front.
Be careful not to tilt the module when pulling it out
of the module area: The portafilter switch (12) must
slide smoothly through the opening in the module.

Using the container module

Inserting the container module

1. Place the correctly aligned container module (21) on
the module area (11) under the spout (13) (see Fig. K).
The two pins on the back of the module are aligned
with the corresponding holes in the module area,
and the opening of the portafilter switch cover (22) is
located in front of the portafilter switch (12).
2. Press and hold down the pushbutton on the side (7)
and slide the module into the module area.
28