Battery Dismounting, Information, Recharging - Kolida KTS-442UT Series Manual

4) Use plate vial to level the instrument accurately.
①Rotate the instrument horizontally by loosening the Horizontal Clamp Screw and place the plate vial parallel to
the line connecting leveling screw A and B, and then bring the bubble to the center of the plate vial by turning the
leveling screws A and B.
②Rotate the instrument 90℃, make it perpendicular to the connecting line of level screws A and B. Turn level
screw C to make the bubble of the plate vial in the middle.
5) Precisely centering and leveling
Through observation of optical plummet, slightly loosen the central connecting screw and move the instrument
evenly (Don't rotate the instrument), making the instrument precisely collimating to the station point. Then tighten
the central connecting screw and level the instrument precisely again.
Repeat this operation till the instrument collimate precisely to the measurement station point.

3. BATTERY DISMOUNTING, INFORMATION, RECHARGING

· Battery Removal Caution
☆ Before taking the battery off, make sure that the power is turned off. Otherwise, the instrument can be
damage.
PROCEDURE
1. Put the battery on the main body of instrument.
2. Press the locking buttons on the top of battery to lock it.
PROCEDURE
1. Press the clamps on the top of the battery.
2. Take off battery.
Battery Power Remaining Display
·
3-5：70～100﹪
2：50﹪ battery power can last for almost 1 hour
1：10～50﹪ it is better to finish measuring soon, recharge it.
0： 0～10﹪ battery can last only less than 10 minutes only
Note: ① Working time of the battery is determined by environment condition, recharging time and etc.
② The remaining energy level of battery is related to current measuring mode.
· Battery Recharging
☆ Battery should be recharged only with the charger NC-30 together with the instrument.
☆ Remove on-board battery from instrument and connect to battery charger. When the indicator lamp on the
battery charger is orange, the recharging process has begun and will be completed in about 1.5 hours. When
Inserting the battery
Removing the battery
Full power
Meas.
ZA 92°36'25"
HAR 120°30'10"
SD SHV HSET
PC -30
PPM 0
3
P1
EDM
21