Battery Removal & Insertion - Information And Recharging - Kolida CTS-632R10M Manual

2.5 Battery Removal & Insertion – Information and Recharging
Insert the battery into the battery slot and push the battery until it clicks.
Press the right and left buttons of the battery compartment to remove the battery.
Battery information
Please stop the operation when battery is in low voltage, and change a recharged battery
for operation.
Note:
1) The working time of the battery is determined by environment conditions, such as:
surrounding temperature, recharging time and recharging frequency. For safety, recharge the
battery in advance or prepare a recharged battery for use.
2) The display level of leftover battery capacity is related to current measurement
model,even the leftover battery is enough to in angle measurement mode,but you cannot
make sure it is enough to use in distance measurement mode. Because the power
consumption of distance measurement model is higher than angle measurement model,when
turn the angle measurement model to distance measurement model, sometimes it may stop
measure distance and the instrument shut down because of insufficient capacity of battery.
Battery Recharging :
Battery should be recharged only with the specified charger.
The charger should be connected with 220V power supply first when recharging ,then
remove the battery from instrument ,put the plug of the charger into the socket.
Battery Removal Caution
▲Before you take the battery out of the instrument, make sure that the power is
turned off. Otherwise the instrument would be damaged.
7