Charging Voltage; Charging Current - Hama 136686 Operating Instructions Manual

Automatic battery charger

Hide thumbs Also See for 136686:

Operating instructions manual (72 pages)

Table of Contents

Available languages

6.6 Recover 12 volt

Warning – Only for 12-volt lead-acid batteries

• Use the Recover mode solely for 12-volt lead-acid batteries

(liquid electrolyte, gel, maintenance-free (MF), AGM) that

are already aged and no longer fully functional!

• New and fully functional 12-volt batteries can be damaged

through the Recover mode.

• In Recover mode, there may be increased escape of

explosive gases from the battery. Avoid sparks, heat and

fire in close proximity, and run the Recover mode only in

well-ventilated spaces.

• Never use the Recover mode for 6-volt batteries! As a

faultless 6-volt battery can also be detected as a deeply

discharged 12-volt battery, the 12-V Recover mode can be

inadvertently set. These batteries are overcharged with the

high charging voltage and damaged.

• Never use the Recover mode for 12.8-volt 4-cell LiFePO

batteries! These batteries are overcharged with the high

charging voltage and damaged.

Depending on the degree of ageing and chemical degradation,

this charging programme CAN regenerate a deeply discharged

lead-acid battery to a certain extent.

• Press and hold the MODE selection button (1) as described

in Point 6.5, to select the Recover 12 V charging programme.

• If the battery is too damaged and cannot be recovered (no

increase in voltage to 12 V within 3 hours), the fault symbol (F)

flashes and the charger ends the Recover programme (Standby).

• Promptly obtain a replacement battery from a specialist retailer.

7. Care and Maintenance

Note

Disconnect the device from the power supply before cleaning

it or if it is not going to be used for a long period of time.

• Only clean this product with a slightly damp, lint-free cloth

and do not use aggressive cleaning agents.

• Make sure that water does not get into the product.

8. Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no

warranty for damage resulting from improper installation/

mounting, improper use of the product or from failure to

observe the operating instructions and/or safety notes.

9. Technical Data

Supply voltage

Output

Rated output voltage

Rated output current