Table of Contents
Advertisement
Your wiring expert
Product interface and key introduction
RJ11
USB
Main tester (NF-868-M)
Main unit port instructions
(1). Two RJ 45 interfaces on the main unit:
one of them is "MAIN" interface (M interface in short),
and the other is "SCAN" interface (S interface in
short); there are also RJ11 interface, USB interface
and BNC interface;
(2). M interface is used for measuring length and
others, but not for cable Line finding; S interface is
used for Line finding test and "local" connection test;
(3). RJ11 interface, USB interface and BNC interface
on the main unit are used for
line-to-line, length and Line
finding test.
(M)
(S)
MAIN
SCAN
BNC
NF-868-M
Wire mapping
Cable Length
Scan Cable
C o n f i g u r e
UP
ON/OFF
DOWN
ENTER
EMITTER
Cable Tester
&
Wire Tracker
-04-
POWER
NF-868-S
RECEIVER
VOL
PUSH TO TEST
Cable Tester
&
Wire Tracker
Receiver (NF-868-S)
BNC
NF-868-R
RJ45
Remote identifier (NF-868-R)
USB
RJ11
Advertisement
Table of Contents
