Table of Contents
Advertisement
b.Cable length test:
No matter whether the cable far end is connected with a remote adapter (R),
the equipment can perform pairing and length measuring. Therefore, during
the whole measuring process, the remote identifier (R) can be connected all
the time to avoid repeated plugging. Firstly insert one end of the cable to be
tested into "M" port in the main tester. When entering length testing function,
press "ENTER" key to perform pairing and length testing with the equipment.
At this time, the following interface is shown:
Note:
Due to different technical parameters with different branded cables,
users are recommended to use dynamic calibration function of the equipment
before measuring length (Refer to the related chapter for more details.).
Test result 1: Short circuit
If there is short circuit with the cable and terminal, the following interface is
shown (Short circuit with 2 and 3)
At this time, press any key to return to the main menu, and then press "ENTER"
key for re-test.
Please do not perform test again until short circuit problem solved.
Test result 2 In case of normal pairing and length test,
:
the following interface is shown:
Wherein, the digits after pairing (e.g. 12) is the cable number of pairing. "Open" i
ndicates only one end of the twisted-pair cable is connected with "M" end, and
those follow "Open" are lengths of the cable.
At this time, press any key to return to the main menu, and then press "ENTER"
key for re-test.
- - - -
- - - -
identify
Short mapping:
1 2 3 4 5 6 7 8
12
105.5m
Open
36
105.3m
Open
45
105.0m
Open
78
105.2m
Open
-11-
Your wiring expert
Advertisement
Table of Contents
