Table of Contents
Advertisement
Test result 1: Short circuit
If there is short circuit with the cable and terminal, the following interface is shown
(Short circuit with 3 and 6)
At this time, press any key to return to the main menu, and then press
"ENTER" key for re-test.
Please do not perform test again until short circuit problem solved.
Test result 2:
Fail to find remote adapter (R) or local port (S) cable: if
the far end of the cable to be tested is not plugged in a remote adapter (R)
or when to perform local test, cable is not plugged into the local port (S),
the following interface is shown:
At this time, press any key to return to the main menu, and then press "ENTER"
key for re-test.
Test result 3:
automatically detect the remote adapter (R) or local port (S) cable. If it detects
that the far end of the cable to be tested is with a remote adapter (R) or local
port cable, the following interface is shown:
Wherein: "R" line indicates pin position of the remote adapter RJ45 port;
Wherein: "S" line indicates pin position of local RJ45 port;
Wherein: "M" line indicates pin position of local main end RJ45 port.
At this time, press any key to return to the main menu, and then press "ENTER"
key for re-test.
Short mapping:
1 2 3 4 5 6 7 8
Cable open or
too Short !
In case of correct connection, the testing device will
Wire Map: Remote
1 2 3 4 5 6 7 8
M:
R:
1 2 3 4 5 6 7 8
-07-
Your wiring expert
Advertisement
Table of Contents
