Sony HDC-900 Operation Manual page 75

Selecting the Items for Which an
'!' Mark to Light
Use the '!' IND page of the OPERATION menu to
select the items for which an exclamation mark (!)
lights in the viewfinder.
The settings on this page can be confirmed by pressing
the MENU SELECT switch towards CANCEL when
the DISPLAY switch is set to ON.
Use the following procedure to make the selection.
1
Set the DISPLAY switch to MENU.
2
Turn the MENU SELECT knob, to display the '!'
IND page, then press the MENU SELECT switch
toward ENTER.
'!' IND page
<'!' IND>
[IND] [NORMAL]
ND :c ON
CC : ON
WHITE : ON
D5600K: ON
GAIN : ON
SHUTT : ON
FAN : ON
EXT : ON
FORMAT: ON
The current settings of each item appear to the
right of the item.
The above figure shows the default settings. All
items have been set to ON at the factory. However
the conditions whether an exclamation mark (!)
lights up depend on the settings at the NORMAL
column. You can change these conditions.
Item Condition to light (Factory setting)
ND When any ND filter other than 1 is
selected
CC When any CC filter other than B is
selected
WHITE When the WHITE BAL switch (white
balance memory) is set to the position
other than A and B
D5600K When D5600K is set to ON on the
OTHERS page. When D5600K is set to
OFF on the OTHERS page, the ! mark
does not light even if IND is set to ON on
this page
GAIN When the GAIN switch is set to any
position other than L
2
1---
-B--
-AB
OFF
L--
OFF
AUTO1
OFF
59.94I
SHUTT When the electronic shutter is used
FAN When FAN mode setting with the
MAINTENANCE menu is other than
AUTO1
EXT When the lens extender is in use. When
the lens extender is not in used, the !
mark does not light even if IND is set to
ON
FORMAT When the format other than 59.94I is
selected
3
Perform the desired settings for each item.
Whether the exclamation mark should light or not
is set in the IND column.
1 Turn the MENU SELECT knob to move the
arrow marker (c) to the item you want to set,
then press the MENU SELECT switch toward
ENTER.
The arrow marker (c) changes to a question
mark (?).
2 Turn the MENU SELECT knob to select ON or
OFF as desired, then press the MENU SELECT
switch toward ENTER.
The "?" mark changes back to the arrow marker
(c) .
When you select ON in step 2, set the condition
for lighting in the NORMAL column by selecting
the normal condition where the ! mark dones not
light. When you select OFF, proceed to step 4.
3 Turn the MENU SELECT knob to move the
arrow marker (c) to the NORMAL column of
the item you select in step 1, then press the
MENU SELECT switch toward ENTER.
The arrow marker (c) changes to a question
mark (?).
4 Turn the MENU SELECT knob until the
desired setting is displayed, then press the
MENU SELECT switch toward ENTER.
(Continued)
29(E)