Sony HDC-900 Operation Manual page 57

1 Video signal select buttons
Select the video output signal (R, G, or B) to the
viewfinder.
The R, G, and B buttons may be pressed individually
or in combination. The signal corresponding to each
pressed button will be output. When two buttons are
pressed, the output of will consist of those two signals
mixed together.
The video output to the monitor connected to the
TEST OUT connector will always be the Y signal
regardless of these buttons.
When a color viewfinder is used:
• When all three buttons are pressed, the output to the
viewfinder and monitor will be the Y signal.
• When no button is pressed, the output to the
viewfinder will be the color signals and that to the
monitor will be the Y signal.
2 POWER indicator
This indicator lights up or goes off as follows to
indicate the power supply status:
Green: Power is being supplied to the camera.
Red: The CAM PW button of the MSU-700A/750
Master Setup Unit or RCP-700 series Remote
Control Panel is set to OFF.
Yellow: Power is being supplied to the camera, but
the VF PW button of the MSU-700A/750 Master
Setup Unit or RCP-700 series Remote Control
Panel is set to OFF, and power is not being
supplied to the viewfinder.
Off: Power is not being supplied to the camera.
3 ND filter selector
When the FILTER LOCAL button is lit up, this
selector may be used to select an ND filter.
Selector position Selected filter
1 Clear
2 1/4ND
3 1/8ND
4 1/16ND
5 1/64ND
4 CC (color temperature conversion) filter
selector
When the FILTER LOCAL button is lit up, this
selector may be used to select a color temperature
conversion filter appropriate to the light source
illuminating the subject.
Selector position Selected filter
A Cross filter
B 3200K (clear)
C 4300K
D 6300K
E 8000K
5 FILTER LOCAL (filter local control) button
Pressing this button enables selecting of a color
temperature conversion filter or ND filter using the CC
filter selector and ND filter selector. Pressing the
button again gives control of the filters to the MSU-
700A/750 Master Setup Unit or RCP-700 series
Remote Control Panel.
6 UP TALLY switch
Set whether or not the camera's Up Tally lamp and the
lens' tally lamp will light when the camera receives a
red tally signal.
ON: The tally lamps will light.
OFF: The tally lamps will not light.
7 VF (viewfinder) SCAN switch
Used to control the viewfinder screen display.
16:9: To set the viewfinder display to 16:9 aspect
ratio.
4:3: To set the viewfinder display to 4:3 aspect ratio.
8 SCREEN SIZE MARKER switch
Used to control the display of the screen size marker as
follows:
ON ( ): Areas outside the specified ratio area will
be darkened.
ON ( ): The screen size marker (white lines) will be
displayed.
OFF: The screen size marker will not be displayed.
9 CENTER MARKER switch
Used to control the display of the center marker as
follows:
ON: A marker indicating the center of the picture
area will be displayed on the viewfinder screen.
The position of the center marker may be adjusted
for the lens being used. The adjusted position
may be stored in a lens file.
OFF: The center marker will not be displayed.
For more information, refer to the System Manual.
11(E)