Sony HDC-900 Operation Manual page 55

qf TRACKER connector (20-pin)
Used for communication between the camera operator
and the tracker, and also for intercom channels 1 and
2. It also supplies the up tally signal and the program
audio signal.
qg RET (return video) CONTROL connector
(6-pin)
This connector allows an external controller to switch
return video 1, 2, and 3, as well as turn the intercom
microphone on and off.
qh DC OUT connector (4-pin)
Used to supply power (12 V, 5 W maximum) to a
script light of the BKP-7911/7912 Script Holder.
qj CCU (camera control unit) connector (electro-
optical multi-connector)
Connect to the CAMERA connector of the HDCU-900
Camera Control Unit using an electro-optical
composite cable. Power and video, audio, and control
signals are passed between the camera and the control
unit using just one cable.
qk DC IN connector (4-pin)
Connect to a DC power source (10.5 to 17 V) when
using the camera as a stand-alone unit.
ql AC OUT connector
Used to supply AC power (200 VA maximum).
w; VTR connector (26-pin)
When using the camera in stand-alone use, a VTR can
be connected using an HDCZ cable to this connector.
In this case, however, the VTR cannot be started or
stopped from the camera.
wa HD SERIAL OUT connector
A serial digital interface with a transfer speed of
1.5 Gbps, this connector may be used to output a video
signal to a monitor or VTR.
9(E)