Function Code 40 Dtmf Relay 1; Function Code 41 Dtmf Relay 2; Function Code 42 Relay 2 Mode - PACH & COMPANY QUANTUM QR5 Series Programming Manual

QR5/QR5IP SERIES MANUAL
2. Enter 39 then #
3. Press
0= disable remote access
1= enable remote access (default)
then press #

Function Code 40 DTMF Relay 1

By default the DTMF remote opening relay 1 (door 1) key number is set to 9 means pressing 9 will remotely trigger relay 1
(door 1). The number can be changed by selecting 1-9 to trigger relay 1 (door 1). Note: by default remote access for relay
2 is set to 8, see function code
number even though relay 2 is not used.
1. Log-in to programming
2. Enter 40 then #
3. Press 1-9 (9 is default setting) then press #

Function Code 41 DTMF Relay 2

By default the DTMF remote opening relay 2 (door 2) key number is set to 8 means pressing 8 will remotely trigger relay 2
(door 2). The number can be changed by selecting 1-9 to trigger relay 2 (door 2). Note: by default remote access for relay
1 is set to 9, see function code
number even though relay 1 is not used.
1. Log-in to programming
2. Enter 41 then #
3. Press 1-9 (9 is default setting) then press #

Function Code 42 Relay 2 Mode

Relay 2 can be set to four different mode: 1= door control, 2= trigger simultaneously as relay 1, 3= alarm mode (see
function code 24), 4= turn relay 2 on/off remotely (DTMF key7/6)
file:///C|/PACH-CO.COM-2022-B/online_manual/qr5_manual.htm[4/25/2022 2:58:06 PM]
41. If you set relay 1 for key number 8 then you MUST change relay 2 to different key
42. If you set relay 2 for key number 9 then you MUST change relay 1 to different key