Function Code 40 Dtmf Relay 1; Function Code 41 Dtmf Relay 2; Function Code 42 Relay 2 Mode - PACH & COMPANY QUANTUM Q9000VOiP SERIES Manual

QUANTUM QVOIP SERIES MANUAL
1. Log-in to programming
2. Enter 39 then #
3. Press
0= disable remote access
1= enable remote access (default)
then press #

Function Code 40 DTMF Relay 1

By default the DTMF remote opening relay 1 (door 1) key number is set to 9 means pressing 9 will remotely trigger relay 1 (door 1). The number can be
changed by selecting 1-9 to trigger relay 1 (door 1). Note: by default remote access for relay 2 is set to 8, see
number 8 then you MUST change relay 2 to different key number even though relay 2 is not used.
1. Log-in to programming
2. Enter 40 then #
3. Press 1-9 (9 is default setting) then press #

Function Code 41 DTMF Relay 2

By default the DTMF remote opening relay 2 (door 2) key number is set to 8 means pressing 8 will remotely trigger relay 2 (door 2). The number can be
changed by selecting 1-9 to trigger relay 2 (door 2). Note: by default remote access for relay 1 is set to 9, see
number 9 then you MUST change relay 1 to different key number even though relay 1 is not used.
1. Log-in to programming
2. Enter 41 then #
3. Press 1-9 (9 is default setting) then press #

Function Code 42 Relay 2 Mode

Relay 2 can be set to four different mode: 1= door control, 2= trigger simultaneously as relay 1, 3= alarm mode (see
on/off remotely (DTMF key7/6)
1. Log-in to programming
2. Enter 42 then #
file:///C|/PACH-CO.COM-2020/online_manual/q9000voip_series_manual.htm[1/17/2020 10:02:05 AM]
function code 41. If you set relay 1 for key
function code 42. If you set relay 2 for key
function code 24), 4= turn relay 2