General Errors - Bosch Rexroth R-IB IL 24 PSDO 8-PAC Manual

60/94 Bosch Rexroth AG
Errors: Messages and Removal
9.4

General Errors

Error cause Error code
(hex)
Device 01F2
temperature
at critical
value
Error due to 01F3
receipt of an
unexpected
message
Error due to 01F4
receipt of an
unexpected
value in the
process data
image
Hardware
fault
Fig. 9-5 General errors
Acknowledgment: Yes (1)
Acknowledgment: Yes (2)
Rexroth Inline Module with Safe Digital Outputs R-IB IL 24 PSDO 8-PAC
LED Remark
Error due to receipt
of an unexpected
message while
acknowledging a
diagnostic
message.
The device firmware
handles this
diagnostic message
with the highest
priority. Only when
this message has
been acknowledged
correctly are other
errors indicated (if
present).
At least one
reserved bit in the
process data image
was set.
FS ON Error in the logic
area
Acknowledging the diagnostic message deletes the message.
Acknowledging the diagnostic message deletes the message and enables the out-
puts.
DOK-CONTRL-ILPSDO8****-AW04-EN-P
Effect Remedy
Immediate Check and adapt:
shutdown. Further
• Ambient
temperature
conditions
increase causes the
• Derating
module to switch to
• Output loads
the safe state.
• Switching
frequency
The Check and adapt the
acknowledgment assignment of the
process, during diagnostic and
which an confirmation
unexpected variables at the
message was DEVICE_STATE
received, is aborted. function block.
The corresponding
Acknowledge
error remains in the
diagnostic message
error memory.
01F3 so that the next
Diagnostic message
message from the
01F3 is indicated.
error memory can be
indicated.
All outputs are Check process data
disabled assignment.
immediately. A
parameterized
switch-off delay is
not observed.
Module is in the safe Replacement
state
Acknow-
ledgment
Yes (1)
Yes (1)
Yes (2)