Table of Contents
Advertisement
Important Information — Please Read Before Use
6
•
Never insert or withdraw the endoscope's insertion tube with
excessive force. Otherwise, patient injury could result.
•
Do not pull the universal cord during an examination. The
endoscope connector will be pulled out from the output
socket of the light source and the endoscopic image will not
be visible.
•
Do not coil the insertion tube or universal cord into a diameter
of less than 12 cm. Equipment damage can result.
•
Do not touch the electrical contacts inside the electrical
connector. CCD damage may result.
•
Do not apply shock to the distal end of the insertion tube,
particularly the objective lens surface at the distal end.
Visual abnormalities may result.
•
Do not twist or bend the bending section with your hands.
Equipment damage may result.
•
Do not squeeze the bending section forcefully. The covering
of the bending section may stretch or break and cause water
leaks.
•
Turn the video system center OFF before connecting or
disconnecting the videoscope cable from the electrical
connector on the endoscope. Turn the switch ON or OFF
only when the videoscope cable is connected to both the
video system center and electrical connector on the
endoscope. Failure to do so can result in equipment damage,
including destruction of the CCD.
•
The endoscope's remote switches cannot be removed from
the control section. Pressing, pulling or twisting them with
excessive force can break the switches and/or may cause
water leaks.
•
If remote switch 1 does not return to the OFF position after
being pressed strongly from the side, gently pull the switch
upwards to return it to the OFF position.
•
Do not hit or bend the electrical contacts on the endoscope
connector. The connection to the light source may be
impaired and faulty contact can result.
•
Do not attempt to bend the endoscope's insertion tube with
excessive force. Otherwise, the insertion tube may be
damaged.
EVIS EXERA TJF TYPE 160VR OPERATION MANUAL
Advertisement
Table of Contents
