Olympus EVIS EXERA TJF-160VR Instructions Manual page 36

Chapter 3 Preparation and Inspection
32
1.
Keep the bending section straight and move the elevator control lever to set
the forceps elevator beside the side wall area of the distal end as shown in
Figure 3.15.
White ring
Bending section
Figure 3.15
2.
Gently hold the covering of the bending section as close to the distal end as
possible (see Figure 3.16). Hold the top end of the distal cover with the
metal insert (see Figure 3.16). Align the indication mark on the white ring
with the indication mark on the distal cover.
Figure 3.16
EVIS EXERA TJF TYPE 160VR OPERATION MANUAL
Forceps elevator
Distal end
Side wall area
Indication mark
Indication mark
White ring
Hook