Cleaning Or Replacing The Filter Mat - KAESER SK 19 Service Manual

 Place the new V---belts over the motor and compressor pulleys without straining them.
 Set the belt drive tension (see chapter 9.4).
Attention!
9.6

Cleaning or Replacing the Filter Mat

Clean the filter mat every week depending on the dust content of the intake air and replace
if necessary as detailed in the maintenance schedule (see chapter 9.2).
 Switch off the compressor package (see chapter 8.3).
1
3
3
1 Filter
2 Holding frame
3 Closure
 Press closures (3) inwards and remove the holding frame.
Cleaning:
Rinse the mat in warm water ( approximately 105•F), if necessary, use a mild detergent
soap to rinse out oily dust. The mat can also be tapped, vacuum cleaned or blown out with
compressed air (not in excess of 30 psig).
Attention!
 Locate the holding frame and press into position.
The holding frame is secure when the closures engage.
Check the belt drive tension after 2 hours of operation and then again
after 24 hours of operation, as experience shows that the belts stretch
mostly during this period.
Lock the main disconnect switch in the "off" position in accordance
with applicable lockout/tagout procedures to ensure the compressor
does not restart.
If the mat is heavily soiled or has been cleaned often (maximum five
times), replace it.
3
2
2
3
Maintenance
9 --- 43