Table of Contents
Advertisement
Install the unit by screwing two screws. It's recommended to use M4 or M5 screws.
Battery Connection
CAUTION: For safety operation and regulation compliance, it's requested to install a separate DC over-current
protector or disconnection device between battery and the inverter. It may not be necessary to have a
disconnection device in some applications, however, it's still recommended to have over-current protection
installed. Please refer to typical amperage as required.
WARNING! All wiring must be performed by a qualified electrical technician.
WARNING! It's very important for system safety and efficient operation to use
appropriate cables for battery connection. To reduce risk of injury, please use the
proper recommended cable in the table below.
Recommended battery cable size:
Model
Amperage
PIP3624MT
PIP5648MT
Please follow below steps to implement battery connection:
1. PIP3624MT model supports 24VDC system and PIP5648MT model supports 48VDC system. Connect all
battery packs as below chart. It is recommend to connect minimum of 100Ah capacity battery for
PIP3624MT model and 200Ah capacity battery for PIP5648MT model.
2. Prepare four battery wires for PIP3624MT model and two or four battery wires for PIP5648MT model
depending on cable size (refer to recommended cable size table). Apply ring terminals to your battery wires
Typical
Wire Size
167A
2*4AWG
1*2AWG
129.6A
2*4AWG
Cable mm
2
Ring Terminal
(each)
Dimensions
D (mm)
25
8.4
38
8.4
25
8.4
5
Ring terminal:
Torque
Value
L (mm)
33.2
39.2
5 Nm
33.2
Advertisement
Table of Contents
