FIGURE 3-6
To Replace the Controller Board
1. Slide the replacement controller board in its canister into the slot in the chassis.
The top of the canister has rails that fit into guide hooks in the chassis.
2. Push firmly until the controller board connector engages.
3. Push both handles inward until they are flush with the canister.
4. Connect the cables and remove the antistatic strap.
5. Turn the power on.
Push the power switch to the momentary on position (right side) and then release it.
Battery (A1000 Only)
You must turn off the power to replace the battery. Note all the cautions and
warnings in this chapter and the safety information at the front of the book.
To Replace the Battery
Replace the battery only with the same type of Sun Microsystems battery.
28
Sun StorEdge A1000 and D1000 Installation, Operations, and Service Manual • February 1998
Removing the Controller Board