Saving Changes - Simplex 4008-9101 Installation, Programming And Operating Instructions

Table 5-5 Event Categories and Codes (Continued)
Event
Manual Test
Report
Off-normal at
test
Note: Event codes for SIA and BFSK are non-editable.

Saving Changes

When DACT programming is complete, press the EXIT/
CLEAR key until the following prompt is shown.
[Cont]
Use the right arrow key to move the cursor to one of the fol-
lowing options and press <ENTER>.
• Cont - continues the edit session.
• Dscrd - exits the edit session without saving your
changes (keeps the job that was loaded before you
started editing).
• Save - saves your edit changes
Note: Both discard and save restart the panel.
Technical Manuals Online! - http://www.tech-man.com
Chapter 5. Manually Programming NACs, Relays, and DACT
3/1 BFSK 4/2
E EE 3A
F F8 33
Dscrd Save
firealarmresources.com
SIA
RX0
YX0
5-11