Globally Acknowledging Alarms - Simplex 4100U Operator's Manual

Acknowledging an Alarm,
Globally
Acknowledging
Alarms
Individually
Acknowledging
Alarms
Technical Manuals Online! - http://www.tech-man.com
Continued
Use the following procedure if the Global Acknowledge option is enabled on your 4100 system.
1. Unlock and open the enclosure door. Read the alphanumeric display on the interface panel.
It reports the number of alarm conditions as shown below.
**FIRE**
Fire =1
2. Press the ALARM ACK key. Read and follow the instructions on the alphanumeric display.
After you press the ALARM ACK key, the system responds as follows:
•
The tone-alert silences and the alphanumeric display reports pertinent information about
the alarm, such as the following:
FIRST FLOOR EAST WING
PULL STATION
•
The SYSTEM ALARM LED changes from flashing to steady ON, and all alarm
conditions are acknowledged.
•
Pressing the ALARM ACK key again displays information on the next alarm. Continue
to do this to review all alarms in the system.
Use the following procedure if the Individual Acknowledge option is enabled on your 4100
system.
1. Unlock and open the enclosure door. Read the alphanumeric display on the interface panel.
It reports the number of alarm conditions as shown below.
**FIRE**
Fire =1
2. Press the ALARM ACK key. A report similar to the one shown below appears. Read and
follow the instructions on the alphanumeric display.
FIRST FLOOR EAST WING
Press ACK key to acknowledge ALARM
PULL STATION
firealarmresources.com
Press <ACK> to review.
PRI2 = 0 SUPV = 0
Press <ACK> to review.
PRI2 = 0 SUPV = 0
2-3
TRBL=0
ROOM 31
FIRE ALARM
TRBL=0
ROOM 31
ALARM
Continued on next page