8504 OPERATOR'S MANUAL – SECTION 3
Figure 3.6 – Closeup of AC Mains Barrier Strip
Figure 3.7 – Closeup of AC Mains Barrier Strip for
208VAC wiring
Figure 3.8 – AC Inlet Safety Cover
96-8005353_02-17-2022
Do not disconnect or disable the protective
grounding connection. Doing so causes a poten-
tial electrical shock hazard.
Connect the AC supply to the three-terminal bar-
rier strip located on the amplifier back panel (see
Figure 3.6 and 3.7).
Install AC inlet cover prior to connecting to the sup-
ply source. See Figure 3.8.
Start-up Procedure
1. Turn down the level of your signal source.
2. Place the back-panel breaker switch in the
3. Press the front-panel Standby-Run switch
4. Wait until the Run/Standby indicator turns
5. Adjust your input signal level to achieve
Information subject to change
WARNING
ELECTRIC SHOCK HAZARD.
AC supply potentials can be lethal. Inlet
cover must remain installed at all times
to protect against HAZARDOUS LIVE
VOLTAGES
ON position.
to the Run position to energize the ampli-
fier.
solid green.
the desired output level.
9