The wearable terminal starts to charge automatically. The amber Charge Status LED lights to indicate the
3.
charge status. See
Wearable Terminal LED Charge Indicators
Table 1-1
LED
Off
Fast Blinking Amber
Slow Blinking Amber
Solid Amber
Charging Spare Batteries
Use the following accessories to charge spare batteries:
Single Slot USB cradle
•
Four Slot Spare Battery charger.
•
To charge a spare battery:
Ensure the accessory used to charge the spare battery is connected to the appropriate power source.
1.
Insert the spare battery into the accessory's spare battery charging slot with the charging contacts facing
2.
down (over the charging pins) and gently press down on the battery to ensure proper contact.
The battery starts to charge automatically. The amber charge LED on the accessory lights to show the
3.
charge status. See
Removing the Main Battery
To remove the main battery:
Prior to removing the battery, ensure that the wearable terminal is in suspend mode. If the wearable
1.
terminal is not in suspend mode, press the Power button to place the wearable terminal in suspend mode.
Press the battery release button. The battery partially ejects from the wearable terminal.
2.
Remove the battery from the wearable terminal.
3.
for charging indications.
Table 1-1
Wearable terminal is not in cradle. Wearable terminal not placed correctly. Charger is
not powered.
Charging error:
Temperature is too low or too high.
•
Charging has gone on too long without completing (typically eight hours).
•
Wearable terminal is charging.
Charging complete.
Note: When the battery is initially inserted in the wearable terminal, the amber LED
flashes once if the battery power is low or the battery is not fully inserted.
for accessory charge LED indicator definitions.
Chapter 2, Accessories
Getting Started
Indication
1 - 5