Connector Shroud
NOTE Use only on the RS409 or RS419 with extended cable.
Assembly
Remove cable from wearable terminal, if required.
1.
Align the cable connector with the connector shroud bottom housing. Ensure that the disconnect button on
2.
the connector faces up.
Bottom Housing
Installing Bottom Housing
Figure 2-26
Place the cable connector into the shroud bottom housing as shown.
3.
Installing Top Housing
Figure 2-27
Press the top housing into the bottom housing. The housings will snap together.
4.
Plug the cable connector into the wearable terminal connector.
5.
Disconnecting the Cable from the Wearable Terminal
NOTE Follow the instructions below when disconnecting the cable connector and shroud from the wearable terminal.
Once the shroud is installed on the connector, do not disassemble the shroud by prying it apart.
Turn the wearable terminal over to expose the top housing of the shroud.
1.
Push the tip of a ball-point pen through the hole in the connector shroud top housing. The connector
2.
disengages from the wearable terminal.
Disconnect Button
Accessories 2 - 25