Installing Batteries In Remote Control - Motorola DCT 2000 Installation Manual

Installing Batteries in Remote Control

Before using the remote control, you must install two AA (1.5 V) alkaline batteries. Figure 2-5
illustrates battery access on the back of the remote control.
To install batteries in an DRC 400:
1
Press and slide the battery compartment cover off.
2
Place the batteries in the compartment; be careful to observe the correct polarity.
3
Slide the battery compartment cover back into place.
Battery installation will vary with each style of remote control. Refer to the instructions included
with your remote control for installing batteries.
F i g u r e 2 - 5
B a c k v i e w o f r e m o t e c o n t r o l
+
+
D C T 2 0 0 0 I n s t a l l a t i o n M a n u a l
O v e r v i e w 2 - 9