Table of Contents
Advertisement
8
Finalizing the Installation
Top Vent or Rear Vent Configuration
This appliance is shipped in the top vent configuration. To change to the rear vent configuration, follow
the directions below.
NOTE: the vent configuration affects several aspects of installation (framing, maximum vent rise,
maximum vent run). Make sure the vent configuration is correct prior to installation. You may wish to
configure the diffuser when changing the vent configuration.
NOTE: Use a magnetic-
tipped nutdriver on these
screws - take care to prevent
the screws from falling into
the fireplace.
© Travis Industries
(for qualified installers only)
Remove the 6 screws
securing the heat shield and
vent cover plate. Remove
both and them it aside.
Remove the 4 screws securing
the intake cover plate. Remove
it and place it aside.
Remove the 12
screws securing the
flue assembly.
Rotate the flue assembly so
the flue points to the rear.
Secure using the twelve
screws removed earlier.
DO NOT OVER-TIGHTEN
THE SCREWS.
6/27/2019 - 1500
864 31K CF Aust
Advertisement
Table of Contents
