Lopi 864 TRV 31K CleanFace Manual page 45

Finalizing the Installation
ALL FIREBACKS
Discard the Floor
Firebacks (if
applicable). They
are not used with
this fireplace.
GLASS
FIREBACKS
Slide the Media Tray
Covers Outwards.
For all other
firebacks, discard
the media tray
covers.
Ledgestone
Firebacks
Bend the tabs on
the media tray out.
Glass Firebacks
Bend the tabs on
the media tray out.
Bend the secondary
tab straight up.
© Travis Industries
Ceramic Firebacks (except for Ledgestone): The media tray is unchanged.
Ledgestone Firebacks: The (6) tabs (4 side , 2 rear) on the media tray must be bent out –
see below. You will need to remove the media tray (2 screws hold it in place) to bend the
tabs out.
Glass Firebacks: The (4) side tabs on the media tray must be bent out (do not bend out the
rear tabs) – see below. You will need to remove the media tray (2 screws hold it in place) to
bend the tabs out. Once the tabs are bend out 90°, you will see the outer edge of the tab is
cut in half. Bend the rear portion of each tab UP 180° so that it is facing directly upward (see
below).
a
(for qualified installers only)
Bend these tabs
outwards (both sides).
6/27/2019 - 1500
The side and back
firebacks rest on top
of these tabs.
b
864 31K CF Aust
45