Setting The Clock; Setting Kilometers Or Miles - KTM 690 DUKE EU Packaging 4 2008 Setup Instructions

WORK

Setting the clock

3.6

Setting kilometers or miles

3.7
Info
If you change the unit, the ODO value is retained and converted accordingly.
Making the setting according to the country.
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the generator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove the lid
Charge the battery according to the instructions
–
Switch off the charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use.
–
Position the fuel tank. (
–
Mount the seat. (
–
Set the clock. (
100151-10
Condition
The motorcycle is standing.
– Switch on the ignition by turning the ignition key to the position
(690 DUKE USA).
–
Press the MODE button several times until the ODO display mode is active.
–
Keep the MODE button and the SET button pressed simultaneously.
The time begins to flash.
–
Press the MODE button to adjust the hour.
–
Press the SET button to adjust the minute.
–
Keep the MODE button and the SET button pressed simultaneously.
700115-10
The time is set.
Condition
The motorcycle is standing.
– Switch on the ignition by turning the ignition key to the position
(690 DUKE USA).
–
Press the MODE button several times until the ODO display mode is active.
–
Keep the MODE button pressed until the display mode changes from Km/h to Mph or
from Mph to Km/h.
Guideline
Activation duration of MODE button
700120-01
.

3 months
S. 5)
S. 5)
S. 7)
10 s
7
on the battery casing.
