Table of Contents
Advertisement
WORK
Fitting front spoiler
3.8
Refueling
3.9
Danger
Fire hazard Fuel can easily catch fire.
–
Never fill up the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See specifications on filling up with fuel.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse imme-
diately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed,
contact a doctor immediately. Change clothing that has come into contact with fuel.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
Info
This motorcycle is equipped with a regulated catalyst. Leaded fuel will destroy the catalyst. You should therefore use unleaded
fuel only.
–
Position the front spoiler side parts to the center part and latch in.
–
Fit the rubber grommets
300028-01
–
Position the front spoiler to the retaining bracket
do not tighten yet.
Info
Do not forget the insulating washer on the retaining bracket.
300026-10
–
Fit and tighten screw
Guideline
Screw, bug spoiler
–
Fully tighten screws
Guideline
Screw, bug spoiler
300027-10
.
with a flange adapter on both sides.
M6
.
M6
. Fit screws
with bushes, but
7 Nm (5.2 lbf ft)
7 Nm (5.2 lbf ft)
8
Advertisement
Table of Contents
