KTM 690 DUKE EU Packaging 4 2008 Setup Instructions page 5

SET‑UP
2 S ET‑UP
Unpacking and setting up the vehicle
2.1
–
Remove the box and the plastic packaging.
Info
To avoid damaging the motorcycle when mounting the handlebar, do not
remove the plastic on the fuel tank until after all of the work has been com-
pleted.
–
Check the vehicle for transport damage.
–
Unpack the separate enclosure and check its contents on the basis of the enclosure
list.
700211-01
–
Remove the operating elements from the transport holder. Remove the screws and
handlebar clamps. Remove the transport holder.
700212-01
–
Position the operating elements on the right half of the handlebar.
–
Position the handlebar.
–
Position the handlebar clamps. Fit and slightly tighten the four screws.
700213-01
–
Position the handlebar exactly.
The mark 1 of the scale on the handlebar should be in the center of the han-
dlebar clamp.
–
Tighten the four screws evenly.
Guideline
Screw, handlebar clamp
–
Mount and tighten the right handlebar weight.
100322-10
–
Position the operating elements on the left half of the handlebar.
Info
Position holding lug
700214-01
–
Mount and tighten the rear mirror adapter and rear mirror on both sides.
–
Position all operating elements exactly on the handlebar. Tighten all screws.
700215-01
M8
in bore .
 
3
20 Nm
(14.8 lbf ft)