Assembly - Grizzly G0717 Owner's Manual

assembly

assembling the g0717 requires connection of the
control panel to the top of the saw bow and instal-
lation of the motor and pulley cover.
to assemble your machine:
1.
remove the two hex bolts and washers
shown in figure 10 from the top of the saw
bow.
hex Bolts & Washers
figure 10. Remove hex bolts.
2.
remove any remaining packing material from
around the control panel, then place it in posi-
tion on top of the saw bow, being careful not
to twist the cords/hoses.
3. secure the control panel as shown in figure
11, using the hardware removed in step 1.
Control panel
hex Bolts &
figure 11. Attaching control panel.
-16-
Washers
4. remove the motor pivot pin from the saw bow
(see figure 12 for location).
pivot pin
figure 12. Mounting motor.
5. With the help of one or more assistants, lift
the motor into position and re-insert the motor
pivot pin.
6. secure the motor pivot pin with the hardware
removed in step 4 (see figure 12).
7. place the belt over the pulleys.
8. remove the hex bolt shown in figure 13.
hex Bolt
figure 13. Motor adjustment bolt.
9. rotate the motor tilt plate upward until it
aligns with the hole from which the hex bolt
was removed in step 8, then re-install the
hex bolt.
10. tension the belt according to step 5 in v-Belt
on page 43.
Model g0717 (Mfg. since 9/10)
pin hardware
Motor