Pre-Installation And Application Warnings - Directed Directechs DB3 Installation Manual

Hide thumbs Also See for Directechs DB3:

Table of Contents

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.

Refer to the "Vehicle connections" section following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin or if

not supported in data.

[2] Tach wire: An optional connection required on some remote starters, which do not support a tach signal in D2D.

[3] Lock/Unlock wires: If there are no Lock/Unlock wires, you can insert them directly as shown on the "Adding wires to an empty pin"

section.

403.MIT4 2.07 2012 Mitsubishi Galant

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation

Table of Contents

Do you have a question about the Directechs DB3 and is the answer not in the manual?