Directed Directechs DB3 Installation Manual page 11

Additional remote start connections
(Not all of these connections may be required for your installation. Refer to the wiring diagram for vehicle-specific connections.)
Wire
12 Volts
Accessory
Clutch Pedal - Must use a relay
Hood Pin
Ignition
Power Lock
Power Unlock
Second Accessory
Starter
Tachometer
Trunk/Hatch Release
Turn Signal (Left) - Must use a diode
Turn Signal (Right) - Must use a diode
11 403.MIT4 2.07 2012 Mitsubishi Galant
©2022 VOXX•DEI LLC. All rights reserved.
Connects To
Wire Location
ignition switch, white 6 pin plug, pin 1
ignition switch, white 6 pin plug, pin 4
Not Applicable
ETACS-ECU on left rear of dash fuse box, white 24
pin plug, pin 4
ignition switch, white 6 pin plug, pin 2
ETACS-ECU on left rear of dash fuse box, white 24
pin plug, pin 13
ETACS-ECU on left rear of dash fuse box, white 24
pin plug, pin 14
ignition switch, white 6 pin plug, pin 6
ignition switch, white 6 pin plug, pin 5
any fuel injector
dash fuse box, top, white 15 pin plug, pin 8
dash fuse box, top, white 15 pin plug, pin 13
(+/-) Wire Color
+ blue/yellow (40A)
+ blue/red
- blue/white
+ black/white
- violet
- lt. green/red
+ blue/black
+ black/yellow
ac NOT red
use trunk release motor
+ green/red
+ green/yellow