Yale ERC40VH Manual page 90

Use this submenu to view the manufacturer's internal hardware and software versions of the Pump Motor
Controller. The manufacturer's hardware and manufacturer's software version information is presented on the
screen as shown in Figure
TRACTION MOTOR CONTROLLER 1 VERSIONS
The manufacturer's hardware and software versions may not match the hardware and
NOTE:
software versions shown on the device's exterior label.
Use this submenu to view the manufacturer's internal hardware and software versions of Traction Motor
Controller 1.
If the truck is equipped with two traction motors, this submenu displays the versions for the
NOTE:
right side traction motor only.
The manufacturer's hardware and manufacturer's software version information is presented on the screen as
shown in Figure 46.
TRACTION MOTOR CONTROLLER 2 VERSIONS
The manufacturer's hardware and software versions may not match the hardware and
NOTE:
software versions shown on the device's exterior label.
Use this submenu to view the manufacturer's internal hardware and software versions of Traction Motor
Controller 2. Traction Motor Controller 2 controls the left side traction motor.
The Status Menu displays this item only if the CDF configuration indicates dual traction
NOTE:
motors are present.
The manufacturer's hardware and manufacturer's software version information is presented on the screen as
shown in Figure 46.
LIGHT CONTROLLER VERSIONS
The manufacturer's hardware and software versions may not match the hardware and
NOTE:
software versions shown on the device's exterior label.
Use this submenu to view the manufacturer's internal hardware and software versions of the Light Controller.
The manufacturer's hardware and manufacturer's software version information is presented on the screen as
shown in Figure 46.
IMPACT SENSOR VERSIONS
Hardware and software versions may not match the hardware and software versions shown
NOTE:
on the device's exterior label.
Use this submenu to view the manufacturer's internal hardware and software versions of the Impact Sensor.
If the truck is not equipped with an Impact Sensor, this submenu is not displayed.
NOTE:
The manufacturer's hardware and manufacturer's software version information is presented on the screen as
shown in Figure 46.
INTRODUCTION
This menu is available only when the truck is not moving and the E-Hydraulics controller is in
NOTE:
the neutral position.
To access this menu, cycle through the main menu title screens by pressing the Scroll Back Key ( —) or
46.
Truck Setup Menu