Yale ERC40VH Manual page 79

With no load on the forks, raise them, if they are not already raised.
1
Starting from the Calibration Menu, scroll to the Manual Hydraulic End Point Calibration screen and
2
press the Enter Key.
When prompted, move all hydraulic levers to both of their extreme locations; that is, move each lever
3
as far as it will go in both directions.
Press the Enter Key. The system records the extreme locations and returns to the Calibration Menu.
4
INTRODUCTION
The Display Menu is a main menu (top-level menu) that is visible at Supervisor and Service Technician
password access levels. To access this menu, cycle through the main level menu screens by pressing the
Scroll Back Key ( —) or Scroll Forward Key (—▸) until the Display Title Screen is displayed, as shown in
Figure 37.
Figure 36. Manual Hydraulic End Point Calibration
Display Menu
Figure 37. Display Title Screen