screen, as
Figure 24
shows.
The process for viewing and removing the system's operator checklist logs is shown in
—
Scroll Keys
—▸
Activity Log
Main menu
↑
Activity Log
Up
Impact
Arrow/Down
Events Log
Arrow Soft
Submenu
Key
↓
When a person with Supervisor password-level access views the log, any recorded events under Service
Technician-level access are shown as
password logged in at the time of an event, the password appears as
INTRODUCTION
The Calibration Menu is a main menu (top-level menu) that is visible at Service Technician, Supervisor, and
Operator password access levels. The
access this menu, cycle through the main menu title screens by pressing the Scroll Back Key (?—) or Scroll
Forward Key (—?) until the Calibration Title Screen is displayed, as shown in
Table 18.
Access Impact Events Log Screens
Press Enter Key (*)
The most recent
Impact Events Log
entry will display
To remove all log entries:
*****
instead of the actual password number. Also, if there was no
Calibration Menu
Table 9
topic shows the icons displayed on calibration screens. To
Press the Up Arrow or Down
Arrow soft key to scroll through
the log entries
Press Trash Can (#) Key to remove
all entries
*****
Table
18.
Press either Scroll
This log screen is
replaced by the
Key ( — or —▸)
Empty log screen
.
Figure
29.
to exit