Advertisement
3 WORK
3.11
3.12
12
Closing the filler cap
V00557-01
Checking the headlight setting
400726-10
–
Fold down the filler cap.
–
Turn the ignition key 90° clockwise.
–
Push down the filler cap and turn the ignition key counter-
clockwise until the lock closes.
Warning
Fire hazard Fuel is highly flammable, toxic and a
health hazard.
–
Check the filler cap is locked correctly after clos-
ing.
–
Change your clothing in case of fuel spills on them.
–
Rinse the affected area immediately with plenty of
water in the event of contact with the skin.
–
Remove the ignition key and close the cover.
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a mark at the height of the center of the
low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle perpendicular to the wall at a distance
from the wall and switch on the low beam.
Guideline
Distance
A
–
The rider, with luggage and passenger if applicable, now
mounts the motorcycle.
–
Check the headlight setting.
The light-dark boundary must lie exactly on the lower
mark when the motorcycle is ready to operate with the
rider mounted along with any luggage and a passenger if
applicable.
»
If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
B
under the first mark.
5 cm (2 in)
A
5 m (16 ft)
p. 13)
Advertisement
