Safety.and.compliance; Part 15 Rules; Class B Digital Device Or Peripheral - Polycom SoundPoint IP 430 SIP 3.0 User Manual

All manuals and user guides at all-guides.com
No Response from Feature Key Presses
Verify phone is in active state:
• Make a call to the phone to check
for inbound call display and ring-
ing as normal. If successful, try to
press feature keys within the call to
access Directory or Buddy Status for
example.
Display shows "Network Link is Down"
Verify LAN cable is properly connected:
Directories
• Check termination at the switch or
Services
hub (furthest end of the cable from
the phone).
Conference
• Check that the switch or hub is opera-
Transfer
tional (flashing link/status lights) or
contact your System Administrator.
Redial
Hold

Safety.and.Compliance

nection to the network.

Part 15 Rules

This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
ences received, including interference that may cause undesired operation.
Class B Digital Device or
Peripheral
Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential instal-
lation. This equipment generates, uses,
and can radiate radio frequency energy
and, if not installed and used in accor-
dance with the instructions, may cause
harmful interference to radio communica-
tions. However, there is no guarantee that
• Press Menu followed by System Sta-
tus and Server Status to confirm line
is actively registered to the server.
• Reboot the phone to attempt re-reg-
istration to the server.
• Press
1 ABC 2 3 DEF
1 2 3
down to verify LAN port is Active.
ABC DEF
• Reboot the phone to attempt recon-
4 5 6
GHI JKL MNO
4 5 6
GHI JKL MNO
7 8 9
PQRS TUV WXYZ
7 8 9
PQRS TUV WXYZ
0
OPER
* #
0
OPER
1. This device may not cause harmful
interference, and
2. This device must accept any interfer-
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the interfer-
ence by one or more of the following
measures:
1. Reorient or relocate the receiving
antenna.
2. Increase the separation between the
equipment and receiver.
3. Connect the equipment into an outlet
on a circuit different from that to

Sel
Del
followed by Status,
Menu
Network and
Messages
Ethernet. Scroll
Do Not Disturb
Hold