Safety And Compliance; Part 15 Rules; Class B Digital Device Or Peripheral; Modifications - Polycom SoundPoint IP 600 User Manual

No Response from Key Presses No Response from Key Presses
• To check LAN status, press the
Menu key followed by System Sta-
tus and Network Statistics. Scroll
down to see if LAN port shows
Active or Inactive.
• Check the termination at the switch
or hub end of the network LAN
cable. Ensure that the switch/hub
port connected to the telephone is

Safety and Compliance

Part 15 Rules

This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and

Class B Digital Device or Peripheral

Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential instal-
lation. This equipment generates, uses,
and can radiate radio frequency energy
and, if not installed and used in accor-
dance with the instructions, may cause
harmful interference to radio communica-
tions. However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by

Modifications

Rules, the user is cautioned that any
changes or modifications not expressly

Installation Instructions

Installation must be performed in accor-
dance with all relevant national wiring
rules.
All manuals and user guides at all-guides.com
turning the equipment off and on, the user
is encouraged to try to correct the interfer-
ence by one or more of the following
measures:
In accordance with Part 15 of the FCC
approved by Polycom, Inc. could void the
user's authority to operate the equipment.
L'Installation doit être exécutée confor-
mément à tous les règlements nationaux
applicable au filage électrique.
18
operational (if accessible - other-
wise contact your System Adminis-
trator).
• Reboot the telephone to attempt
reconnection to the network.
2. This device must accept any inter-
ferences received, including inter-
ference that may cause undesired
operation.
1. Reorient or relocate the receiving
antenna.
2. Increase the separation between the
equipment and receiver.
3. Connect the equipment into an out-
let on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experi-
enced radio/TV technician for help.