Advertisement
Harley Davidson Road Glide 2015-Up
1. Remove the lower T-27 Torx screws on
either side holding the deflector wings.
(Figure A)
Note: Only the lower (2) need to be
removed.
2. Remove (1) 3/16" Allen screw securing
each turn signal. (Figure B)
3. With a firm grip on the windshield,
remove (4) Phillips screws and set the
windshield aside. (Figure C)
4. Remove the top fairing trim clipped to
the top of the radio. (Figure D)
5. Unplug the turn signals.
FAIRING DISASSEMBLY
(Figure A)
(Figure B)
(Figure C)
(CONT)
6. Remove the speaker grills with a panel
removal tool and remove (1) Torx screw
from each side. (Figure E)
CAUTION: The fairing will be loose at this
point. Have a helper hold it to keep from
damaging it when removing the screws.
7. Remove the fairing and set aside.
8. Remove (4) 3/16" Allen screws from the
sides of the radio.
Note: These screws will be reused in the
Kit Assembly.
CAUTION: Be sure to hold the radio
when removing the last screw so it does
not drop.
9. Unplug and remove the radio.
10. Remove (2) Torx screws securing the
fairing bracket attached to the radio.
Note: This bracket will be reused in
the Kit Assembly. Please note the
orientation of the bracket. The curved
portion faces the rear of the bike.
Continue to Reflashing the Radio
(Figure D)
(Figure E)
REV. 10/15/21 INSTBC-DSPX-HD2
3
Advertisement
