Advertisement
MOBILE APP
CROSSOVER ADJUST
If installing a subwoofer, the front and rear outputs will default to a 100Hz high pass
filter to keep the low frequency signals out. If a subwoofer is not being installed, change
the front and rear crossover points down to 20Hz for a full range signal, or to the lowest
frequency the speakers will play down to.
Selecting High Pass and Low Pass will provide one crossover frequency adjustment. Band
Pass should only be chosen if installing just front speakers, with one dedicated amp for
the woofers/mids, a second dedicated amp for the tweeters, along with a subwoofer.
Select the desired crossover slope, 24db, 36db, or 48 db. Higher is steeper, but it is
recommended that one uses High Pass/24db octave slopes for crossovers on a bike.
13
REV. 10/15/21 INSTBC-DSPX-HD2
Advertisement
