Summary of Contents for Metra Electronics GMLAN11-100
Page 1
INSTALLATION INSTRUCTIONS FOR PART GMLAN11-100 GMLAN11-100 *Read Important Warning On Page 1 Before Attempting Any Installation* The GMLAN11-100 is designed to and MUST be used with the GMOS-100i (SOLD SEPERATELY). Please refer to GMOS-100i for 20 pin connector instructions. APPLICATIONS...
INTERFACE COMPONENTS •A) 4 pin harness with stripped leads •B) 22 pin to 30 pin GMLAN car side harness 4 pin TOOLS REQUIRED FOR INSTALLATION •Cutting Tool •Tape •Crimping Tool •Connectors (I.E. butt-connectors, bell caps, ECT…)
Page 3
TABLE OF CONTENTS Installing The Interface ... 1 Installing The GMLAN11-100 ... 1 Programming SWC ... 2 Testing The GMLAN11-100 ... 2 Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry.
Page 4
Connect the Yellow wire to the constant wire of the aftermarket radio. The GMLAN11-100 comes set up for amplified systems. If the vehicle is not amplified disconnect the 4 pin harness located between the 30 way and 22 way connector.
Page 5
15 seconds until the LED goes into fast blink mode again. TESTING THE GMLAN11-100 • Turn the ignition on, and then turn the aftermarket radio on.