Summary of Contents for Metra Electronics GMLAN29-100
Page 1
INSTALLATION INSTRUCTIONS FOR PART GMLAN29-100 GMLAN29-100 *Read Important Warning On Page 1 Before Attempting Any Installation* The GMLAN29-100 is designed to and MUST be used with the GMOS-100i (SOLD SEPERATELY). Please refer to GMOS-100i BUICK Enclave 2007-10 Lucerne 2006-10 CADILLAC...
INTERFACE COMPONENTS •A) 4 pin harness with stripped leads •B) 22 pin to 30 pin GM harness •C) 16 pin backup camera harness 4 pin TOOLS REQUIRED FOR INSTALLATION •Cutting Tool •Tape •Crimping Tool •Connectors (I.E. butt-connectors, bell caps, ECT…) •D) 16 pin RSE harness...
Page 3
TABLE OF CONTENTS Installing The Interface ... 1 Installing The GMLAN29-100 ... 1 Programming SWC ... 2 Testing The GMLAN29-100 ... 2 Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry.
Page 4
Connect the Yellow wire to the constant wire of the aftermarket radio. The GMLAN29-100 comes set up for amplified systems. If the vehicle is not amplified disconnect the 4 pin harness located between the 30 way and 22 way connector. Connect the supplied 4 pin speaker harness and connect the following: •...
Page 5
• Turn on the aftermarket radio • Press volume up until radio responses TESTING THE GMLAN29-100 • Turn the ignition on, and then turn the aftermarket radio on. • Push the Onstar button, the radio should turn off (radio will mute if mute wire is connected) and you should hear Onstar.