Before You Begin - Montigo D3615 Installation & Maintenance Manual

Fan kit Install/Replace
Figure 27. Fan kit
Before you begin
This kit requires a Proflame 2 control board. For burner and
media tray removal instructions please see burner tray removal
instructions.
CAUTION
Ensure that all power to the appliance is off at the electrical breaker
or fuse before beginning installation. Ensure gas is turned off at the
shutoff valve before beginning installation.
1. Remove the plastic covering from the 2 velcro strips on the
fans.
Figure 27.b prepare velcro strips
2. Starting with the left side, secure the fans in the bottom of
the firebox flush against the bottom and back as shown.
Figure 27.c secure the fans
38
3. Repeat for the remaining fans, making sure connectors are on
the right side.
Figure 27.d secure the fans
4. Locate fan wiring harness.
To Fan
To Control Box
Figure 27.e Locate fan wiring harness
5. Connect control board connector (located fastened on the
bottom leftside of the firebox) to fan harness.
Figure 27.f Connect control board connector
6. Connect fans to harness connectors, tuck wires away from
LED strip.
Figure 27.g Connect fans to harness connectors
Installation
To Fan
To Fan
XG0222